3-jaw self-centring electric gripper
• Plug & p1ay user friendly gripper.
• No electricity con5umption when gripper is engaged.
• No programming required.
• Gripper retention guaranteed in event of blackout.
• Self Adapting jaws part.
• Long life Brushless motor (Brushless DC).
• Built-in motor driver.
• 24 Vdc Low Voltage Power Supply.
• M8x1, 3 poles standard connection.
• Controllable by PLC as a pneumatic valve.
• Fiber-carbon gear reduction.
• 10 milion cycle maintenance-free.
• T-slot style jaws for heavy loads.
• Weight-dimensi0n5-force best trade off.
• Rotary actuator fitting compatible.
• Optional magnetic sensors.
带微处理器逻辑和钳位连接的接线盒
IP66聚苯i乙烯传感器接线盒。• 可使用标准电缆密封套定制的电缆进线/出线。• 使用夹具可以连接多达8个带警告LED的传感器，可以使用跳线设置配置。
按下编程按钮进行简单配置。• 按下按钮时，微处理器存储所连接的全部输入的状态。每次返回相同输入状态时，都会激i活输出。
带可复位熔断器的短路保护。• 可以串联多个盒子以增加可连接的传感器数量（只需按一个按钮即可存储全部传感器的状态）。
单个继电器输出的zui大开关电流达1A，单个晶体管输出的开关电流达30 mA。
编程单个SB8F
在对传感器盒进行编程之前，请确保有线输入处于所需配置（开/关）以启用输出。按下AUTOSET按钮并按住3秒钟，直到READING红灯开始闪烁，然后松开。红灯（READING）闪烁表示微处理器正在读取和存储全部输入的状态。然后红灯熄灭，启用了输出。黄灯（STORED）指示启用输出。
Before programming the sensor box, make sure that the wired inputs are in the confguration (ON/OFF) desired to enable the output. Press the AUTOSET button and hold it down for 3 seconds until the READING red light starts fashing, then release it.The red light (READING) fashing indicates that the microprocessor is reading and storing the state of all the inputs. Then the red light goes off and the output is enabled. Output enabling is indicated by the yellow light (STORED).
以上信息由专业从事快速切换器视频的吉玛泰克于2024/5/2 9:47:06发布
转载请注明来源：http://anshan.mf1288.com/jmtkzdh-2745594624.html
上一条：值班室价格规格尺寸「在线咨询」
